HOW TO MAKE A STRAIGHT THROUGH CABLE

 1. Strip the Cable

Use a cable stripper to remove about 1-2 inches of the outer sheath from both ends of the cable.

Be careful not to damage the internal wires.

2. Untwist the Pairs

Inside the cable, you'll find 4 twisted pairs (8 wires total).

Untwist the wires and straighten them.

3. Arrange the Wires

Use the TIA/EIA-568B standard (commonly used for straight-through cables):

Orange/White

Orange

Green/White

Blue

Blue/White

Green

Brown/White

Brown

4. Cut the Wires

Trim the wires evenly to about 1/2 inch from the sheath.

5. Insert the Wires into the RJ45 Connector

Hold the connector with the clip facing down.

Insert the wires into the connector in the correct order.

Ensure each wire reaches the end of the connector.

6. Crimp the Connector

Place the connector into the crimping tool.

Squeeze firmly to secure the wires and the connector.

7. Repeat for the Other End

Follow the same steps for the other end of the cable.

8. Test the Cable

Use a cable tester to ensure the wiring is correct and the cable functions properly.