My Reflection About Yesterday's Symposium

MY REFLICTION 

About yesterday's symposium, the people who held the symposium were soldiers and they discussed terrorism, the rebels of the Philippines, and how they manipulated students to join their communist party.the National Democratic Front (NDF), the Communist Party of the Philippines (CPP), and the New People's Army (NPA) were the communist organizations. We had a great time throughout yesterday's festivities, especially when they showed off their musical prowess. I was inspired to continue my education and encouraged to persevere by the teacher, who had experienced adversity but never gave up. The tale of the one former CPP/NPA member who joined the Philippine military also captured my attention. Yesterday was a lot of fun, and learning more about the communist organizations in our nation was a worthwhile experience.

What I have learned in p2p hands on

 October 13, 2024

Steps on how to do the p2p networking using Cross Over UTP Cable.

Step 1: Open the PC.

Step 2: click windows+R

Step 3: type ncpa.cpl.

Step 4: click Ethernet and go properties.

Step 5: click v4 and go to properties.

Step 6: type the class A networking of both sides in your partner.

Step 7: go to command prompt.

Step 8: type the IP address on your command prompt.

Step 9: and after all the steps wait for the respdonding and if the tasks is successful you finish the steps.

my refliction 

I learned about p2p handout last Thursday for me there are some difficult to remember but there are some easy.

Learning about peer-to-peer  networks using a crossover cable is a valuable experience for understanding the fundamentals of networking and direct device communication. In a peer-to-peer network  two computers can connect directly without the need for a central server  allowing for file sharing gaming or other collaborative tasks. The use of a crossover cable specifically allows two devices to communicate without a switch or router as it enables the direct transmission of data between the two network interfaces.

How to set-up Computer IP address

 

1.Windows + R.

2. type "nepa.cpl"

3. right click thernet

4. Click properties

5.type your password

 6. to enter the properties Find (TCP/IPv4) and double click.

7. Find "Use the following ip address and click.

8. Type 10.10.10.10 in ID address.

9. Press click Subnet mask at it auto translates

10. Type 10.10.10.1 acting Default Gateway.